Sprinter Bed Area Wall Panel - Left (2007-Current)

Sprinter Bed Area Wall Panel - Left (2007-Current)

Regular price$199.00
Shipping calculated at checkout.

The Sprinter Bed Panels are extremely valuable as they add an additional 2 inches of space! You can sleep sideways (71" total width at deepest section)

This panel is for the bed area on the left side of a Sprinter 144, 170 & 170 EXT 2007-Current.

  *Due to the manufacturing process please expect minor differences in texture/sheen from batch to batch. We have no control over this.

Sized for the Sprinter 144″ or 170" wheel base. If you need more than 50", you’ll need an extra panel for a total of 3x panels. You’ll need to cut the left and right sides in the middle and then “splice in” a section of the extra (third) panel to extend the middle section of the left and right panels.

Panel Dimensions: 50.4″ (128cm) x 35″ (89cm) **Please measure your van carefully to see the space this panel covers

Maximum window cut out size: 39.4″ (100cm) x 19.6″ (50cm)

Van Wall Panels

  • Custom formed for an exact fit.
  • 3mm thick ABS plastic with a light texture, matte sheen, and off-white color
  • Lightweight.
  • Easy to install for a professional look.



The panels can be attached to the van structure in a variety of ways. One approach is to drill holes into the van sheet metal and then attaching the panels using "automotive push clips" (similar to how the few factory-supplied panels in a Sprinter are attached). Alternatively, you could secure the panels with self-tapping screws covered with screw caps. In both cases the push clips or screw head covers can be painted with to match your interior.

Window Cut Outs

For factory glass windows or factory-style windows such as CR Laurence or AMA windows, we recommend you cut the window opening large enough that the metal area surrounding the window is exposed so that you can use magnetic window coverings.

If you're using European-style acrylic windows (Dometic, Artic Tern, etc.) you'll need to construct a 3/4" (20mm) deep wooden frame for the window and then cut the corresponding window opening into the panel. After this you can install the panel and finally the interior window shade.

We recommend using a jig saw with a low tooth count wood blade. Be sure to keep the saw/blade moving so that you don't melt the plastic with the hot blade during the cutting process. After the cut, you can finish the edges with a file or sand paper. You can trim the edges with Trim-Lok type edge guard (1/8" edge and 7/16 leg length). The edge guard can be painted with to match your interior.


This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.

Recently viewed