Direct fit sliding door storage step for 2019+ Mercedes Sprinter vans, adding a clean finished entry area, extra storage space, and a stable step surface for daily van use.
Key Features:
Designed for 2019+ Mercedes Sprinter sliding door step area
Adds usable storage space without taking up interior floor space
Provides a stable step surface for easier entry and exit
Helps finish the sliding door opening for a cleaner interior build
Durable stainless steel construction for daily van use
Powder coated finish for corrosion and wear resistance
Wide flange design for easier installation
Compatible with subfloor thicknesses from 1/2" to 1 1/4"
Can be installed with silicone adhesive or bolted down, depending on build preference
Minor trimming or shimming may be required due to factory sliding door tolerance differences
Measurements:
Length: 54" (1372 mm)
Width: 10" (254 mm)
Height: 6.5" (165 mm)
Storage Cubby Length: 24" (610 mm)
Storage Cubby Width: 8" (203 mm)
Storage Cubby Depth: 6" (152 mm)
Description:
This sliding door storage step is designed to finish the factory sliding door step area on 2019+ Mercedes Sprinter vans while adding practical storage space to your build. It creates a cleaner transition at the entry point and provides a sturdy surface for getting in and out of the van.
The built in storage cubby gives you a convenient place to store small gear, tools, straps, recovery items, shoes, or other frequently used accessories without taking up cabinet or floor space. The powder coated finish helps protect against corrosion, wear, and daily use.
The step is designed to work with common van flooring setups from 1/2" to 1 1/4" thick. For thicker subfloors or vans with factory tolerance differences, minor trimming, shimming, or added trim support may be required for proper fitment.
Important Fitment Note: Due to factory manufacturing variation, Sprinter sliding doors may vary in width by up to 22 mm. Most vans fall within normal tolerance, but minor trimming may be required in select cases for the best fit.
For subfloors thicker than 1 1/4", this step can still be used with an additional trim piece between the bottom lip of the storage step and the factory step. Shims may also be needed between the storage step and the factory step to fill any gaps and provide proper support.
If the corner of the storage step contacts the sliding door rubber seal, lightly grinding the corner may be required to create proper clearance.
